The Ecostrip Pro is an environmentally friendly easy to use Professional grade coating remover.
This new strong, faster acting stripper will remove all sealers including Polyurethanes, water based stains, paints, lacquers and even Artex.
The revolutionary stripper is water based, low odour, low VOC, fast acting and extra strong.
Simply apply the gel, leave for the required time and jet wash, scrape or scrub off the coating.
Ecostrip Pro is suitable for internal or external use.
Features:
- Water Based
- Low Odour
- Safer
- Easy to apply gel
- Fast acting
- Can remove around 1.6 Sq Metre of paint per 1 Ltr.
Recommended Usage on these surfaces:
- Paving bricks
- Printed Concrete
- Stone
- Brick
- Fibreglass
- Wood
- Metal
Useful Information:
- Wear suitable gloves & eye protection
- Ecostrip must be shaken well before use
- For best results use between 10C - 30C
- Do not try to spread the product too far as this will result in poor penetration
- Allow Ecostrip to do its work: do not try to remove too quickly
- Never let the surface become too dry during treatment
Preparation:
- Ensure surfaces to be stripped are dry.
- Protection should be provided for floor coatings, or any surface that may be damaged by Ecostrip (perspex, plastics, rubber etc.)
How to apply
- Cover top with a cloth during opening to avoid splashes.
- Apply generous, even coat & do not brush out. Layer Ecostip onto surface to be stripped with suitable brush..
- Ensure Ecostrip Pro does not dry out. Most coatings will take 30 mins - 1 hour to strip, others may take longer.
- After product has penetrated to be substrate (up to 24 hours), scrape off, leaving surface as clean as possible.
- Rub down using a scrubbing brush or stainless steel pad & water. If working externally you can jet wash the surface off.
- Scrub surface with a broom and Jetwash off. For internal spaces rinse well with water, aggitate with a broom and then allow to dry.
